Cloudflare_WARP_Connect

警告⚠:目前此方法解锁Netflix需要强制IPV4出口并刷出特定出口ip(美区除外)，配合v2ray/xray出口规则修改，原生ip请忽略！

奈飞检测脚本(基于lmc999流媒体检测脚本修改而来，适用于本项目出口ip检测):

bash <(curl -L -s https://raw.githubusercontent.com/HXHGTS/Cloudflare_WARP_Connect/main/check.sh) -I wgcf

1.脚本运行:

CentOS7(vps仅提供ipv4网络):

bash <(curl -L -s https://raw.githubusercontent.com/HXHGTS/Cloudflare_WARP_Connect/main/netflix_support.sh)

CentOS8(vps仅提供ipv4网络):

bash <(curl -L -s https://raw.githubusercontent.com/HXHGTS/Cloudflare_WARP_Connect/main/netflix_support_centos8.sh)

Debian/Ubuntu(vps仅提供ipv4网络):

bash <(curl -L -s https://raw.githubusercontent.com/HXHGTS/Cloudflare_WARP_Connect/main/netflix_support_debian.sh)

CentOS7/8(vps仅提供ipv6网络):

bash <(curl -L -s https://raw.githubusercontent.com/HXHGTS/Cloudflare_WARP_Connect/main/netflix_support_ipv6.sh)

Debian/Ubuntu(vps仅提供ipv6网络):

bash <(curl -L -s https://raw.githubusercontent.com/HXHGTS/Cloudflare_WARP_Connect/main/netflix_support_debian_ipv6.sh)

2.在/usr/local/etc/xray文件夹或/usr/local/etc/v2ray中找到配置文件config.json并按仓库中模板格式修改

3.应该可以正常使用了

warp关闭:

systemctl stop wg-quick@wgcf && systemctl disable wg-quick@wgcf && systemctl status wg-quick@wgcf

warp启动:

systemctl start wg-quick@wgcf && systemctl enable wg-quick@wgcf && systemctl status wg-quick@wgcf

warp重启/切换出口ip:

systemctl restart wg-quick@wgcf && echo 0 | bash <(curl -L -s https://raw.githubusercontent.com/HXHGTS/Cloudflare_WARP_Connect/main/check.sh) -M 4

建议配合看门狗食用!